サンワ製サーボ(SRG-HS/HR, PGS-HR)専用のポストです。
標準品に対し1mm高さを低くしていますので、さらに低重心化が可能になります。
サーボセイバーのメーカーによってはシャーシ下面からはみ出ますので使えません。
XRAY製サーボセイバーの場合、写真のように下側を削る必要があります。
材質:アルミニウム
This post is exclusively for Sanwa servos (SRG-HS / HR, PGS-HR).
Since the height is 1 mm lower than the standard product, it is possible to further lower the center of gravity.
Depending on the manufacturer of the servo saver, it cannot be used because it protrudes from the underside of the chassis.
In the case of XRAY Servo Saver, it is necessary to scrape the lower side as shown in the picture.
Material : Aluminum